LabSat Real-Time GNSS Simulator by LabSat

LabSat Real-Time GNSS Simulator by LabSat

LabSat Real-Time GNSS Simulator by LabSat

The LabSat Real-Time from LabSat is a GNSS Simulator that supports GPS, Galileo, GLONASS and BeiDou constellations. LabSat Real-Time operates in real-time mode (LabSat RT Mode) or as a fully functioning record and replay GNSS simulator. It uses SatGen v3 software to generate a live signal stream to a LabSat RT unit. The unit then converts the RF data from digital to analog with less than 1 second latency. The SatGen v3 software can define the position, route, speed, date, and time, as well as the number of satellites included in the data stream. It can also vary the individual carrier to noise levels for each satellite, allowing the data to be streamed directly into the device.

The LabSar RT has an adjustable output signal level from -83 to -107 dBm in LabSat 2 mode and a fixed -83 dBm in LabSat RT mode. The device supports IQ data format and has a bandwidth of 8.184 MB/s. It requires a DC operating voltage from 8 to 30 V. The simulator is available in a module that measures 170 x 128 x 38 mm.

Product Details

  • Part Number: LabSat Real-Time
  • Manufacturer: LabSat
  • Description: Real-Time GPS/Galileo/GLONASS/BeiDou GNSS Simulator

General Parameters

  • Type: Computer Controlled
  • Equipment Type: Benchtop
  • Output Frequency: 1561 to 1602 MHz
  • Sampling Frequency: 16.368 MHz
  • Channels: Dual Channel
  • Number of Channels: 2
  • Constellations Supported: GPS, Galileo, GLONASS, BeiDou
  • GPS: L1
  • Galileo: E1
  • Interface: USB, Digital I/O
  • Operating Voltage: 8 to 30 VDC
  • Reference Oscillator: Internal, OCXO
  • Reference Oscillator Frequency: 16.368 MHz
  • Output Signal Level: -83 dBm
  • Dimensions: 170 x 128 x 38 mm
  • Weight: 750 gram
  • Note: Bandwidth : 16 MHz, Quantisation : 1 or 2 bit (I & Q), USB Transfer Rate : 8.18 MB per second

Courtesy of everything RF

share post: